preview documents

[michael239]

Hello,

I'd like to ask a couple of questions on the subject:
1. Preview of OpenOffice drawings doesn't show all details of the drawing - omitting some lines for example.
I realize that it's just a preview, but sometimes it would be beneficial to see full picture. And it seems it's
possible - if call to pdf2swf would be done without "-G" parameter. I also understand reasoning behind it -
to make load faster, but again sometimes speed is not as important as complete drawing. So I was just wondering
if there is a simple way to choose parameters passed to pdf2swf?
Found in the forums that it's hardcoded inside OKM, right?
There was also talk about pdf2swf_wrapper script, but using it won't override what's hardcoded, is it correct?

2. It's great, that now there is choice for previewer, and personally I like flexpaper better, but for some reason it doesn't
dispaly PDF documents, it just sits there with rotating circle in the upper right corner and doesn't show anything (OOo documents shown
fine). Same PDF shown just fine with zviewer. Using flexpaper by itself shows document properly.
Any idea what might causing it?

Using OKM 5 Beta.

Thanks in advance,
Michael

[pavila]

Yes, pdf2swf options are hardcoded now. I will try to make them configurables.

Flexpaper support is not as good as zviewer. We are working to improve the integration in future versions of OpenKM.

[michael239]

Thank you pavila for quick response.
Configurables would be great.
Keep up good work!
Regards,
Michael